A single monitor might not be incredibly reliable in major vehicles and vans. In such situation, various monitors would assure very good visibility to all in all components of the car. This may be performed by fixing additional monitors either on the roof from the auto or behind the seats. The beneficial question is the best way to wire extra monitors to an car DVD player?
The monitors might be fixed if the location to become fixed is recognized plus the following factors are obtainable: a measuring tape, pencil, paper, marker, knife, fasteners, scissors, and suitable adapter. The following are a sequential process of fixing countless monitors to the similar DVD player.
Firstly the size of headrest of each seat is measured with the help of a measuring tape. This can be carried out mainly to locate out the size with the monitor that may be fixed. The headrest in which the monitor would be to be fixed is removed off the seat.
Then the outer shape from the monitor that may be to be fixed is drawn making use of a paper and pencil. As soon as it has been drawn the shape is cut out making use of scissors. The paper cutting is then placed behind the seat on the headrest as well as the papers outline is traced working with a pencil or marker. An X is drawn on headrest from the seat.
The headrest is cut along the shape in the X using the aid of knife. This should be done carefully. The covering of headrest is peeled plus the padding is removed. This is completed to provide some room for the monitor that has to be fixed. The padding may be removed till the metal base with the seat is exposed.
After the foam is removed, 1 little hole is drilled in the bottom component of headrest. This will permit the wires to pass via that are essential for connecting the monitor for car DVD players. The fasteners are then placed in such a way that a single finish is on the metal base and after that is set to position.
The wires for the DVD player are then run via the bars of headrest, seat and then the floor. Small holes are usually cut out off the carpet to make way for the wires to pass from the floor to that dashboard. The wires for the video are then connected in the jack readily available within the rear in the DVD player. After the video connections are made the other finish of fasteners are placed at the rear of monitor. The video wires are then connected monitor within the port for video cables. Then the monitor is fixed in its position. It has to be checked that the output and input in the video are connected to the DVD player and the monitor respectively.
Once the following actions are followed with smaller precautions of safety, the several monitors can be attached the same way. Hence this article on the best way to wire additional monitors to an auto DVD unit might be useful.
没有评论:
发表评论